Questions & Answers
Mine is missing also, sure would like to put it where it belongs but have no idea where it goes, theres a bracket on carb looks like it hooked to coil clamp, is that possible?
Willys Jeep Parts Tech:
Email mike@kaiserwillys.com an image of the side of your engine and we can can help.
Email mike@kaiserwillys.com an image of the side of your engine and we can can help.
Have a 68 cj5..... My throttle return spring seems real light. When I push the accelerator, you barely feel any direct pressure of the gas pedal under your feet. I replace the throttle return spring with one from NAPA auto, however this spring too seems pretty weak. Is this throttle return spring a little heavier? That is, is it one that is close to an original, or is it a duplicate of ones found at NAPA?
Willys Tech:
I doubt NAPA would sell the correct one. This is the proper, original tension spring used on that for the 4-134 engine.
I doubt NAPA would sell the correct one. This is the proper, original tension spring used on that for the 4-134 engine.
What is the relaxed length of this spring. thanks
Willys Jeep Parts Tech:
3-1/4"
3-1/4"
Do you have an illustration where this spring goes? Ours is missing. Thanks!
Willys Tech:
It depends on your vehicle. There should be a small tap it clips onto.
It depends on your vehicle. There should be a small tap it clips onto.
This is the same spring that gos' from a bolt on the side of the block to the gas pedal linkage right?
Willys Tech:
Yes that is correct. It is different for some vehicles but it works for all.
Yes that is correct. It is different for some vehicles but it works for all.
