Questions & Answers
Questions: I bought this and a new cross shaft. Shouldn't it slide on the cross shaft fairly easily so it can pivot independently from the clutch arm? I am having a hard time even beating it on there with a hammer. What am i missing?
Question By: Shane on Jun 15 2018 7:44 PM
They should slide on with some pressure but not a hammer. Call me toll free. Ask for me Mike M. I can help.
Answer By: Willys Jeep Parts Tech on Jun 18 2018 9:05 AM
Questions: I have a 47 cj2a jeep, do they make a replacable bushing for the brake pedal if not it must just be worn out then?
Question By: Terry Clements on Aug 21 2017 3:42 AM
You will need to replace the cross shaft and the pedal arm. They dont make an insert.
Answer By: Willys Jeep Parts Tech on Aug 21 2017 5:42 AM
Questions: This part appears to be what I need, except for the fact that the pin where the master cylinder pushrod attaches has a larger diameter, then steps down to where the cotter pin goes. Is there a bushing that I need to take up the slack, or am I missing something in the pic?
Question By: Anonymous on Jun 17 2013 12:00 AM
It is a stright pin. Your pushrod will slide on and you put a washer and cotter pin and you are all set.
Answer By: Willys Tech on Jun 18 2013 12:00 AM
Questions: Can you advise what holds the brake pedal to the master cylinder eyebolt? The two disconnected while driving today. It looks like the pedal has a pin on the end that threads through the eye bolt but the pin doesn't have threads on it... Seems like there should be a nut or cotter pin securing the two. My vehicle is a ' 53 willys wagon.
Question By: Steve on Dec 30 2012 12:00 AM
Your pedal arm has a untreaded stud that takes a cotter pin to hold the eyelet in. The rod is adjustable and goes into the master cylinder.
Answer By: Willys Tech on Jan 2 2013 12:00 AM
Questions: Is this pedal arm a forging or cast?
Question By: Jordan on Jan 29 2012 12:00 AM
I beleive it is cast.
Answer By: Willys Tech on Jan 30 2012 12:00 AM