Questions & Answers
Questions: The original bushing in the spindle does not have the flange. With this bushing, will it allow the axle to come forward through the spindle for the proper distance for the flange and shim?
Question By: Eric Hanson on Jul 31 2017 5:44 AM
Your inner lip has most likely worn off. Make sure to full seat this bushing inside the spindle evenly.
Answer By: Willys Jeep Parts Tech on Jul 31 2017 5:42 AM
Questions: Is this the correct one for a 1944 gpw spindle that has spicer axles in it?
Question By: Robert on Jul 2 2014 12:00 AM
Yes that is correct.
Answer By: Willys Tech on Jul 2 2014 12:00 AM
Questions: My bushing look good how do I know if they are worn is there a ID to check this ?
Question By: Bob on Apr 6 2014 12:00 AM
I would check it for out of roundness and scoring.
Answer By: Willys Tech on Apr 7 2014 12:00 AM
Questions: Can it be used with the Bendix type of axle shaft?
Question By: Robert on Apr 9 2013 12:00 AM
Yes it can.
Answer By: Willys Tech on Apr 9 2013 12:00 AM
Questions: I assume this bushing goes into the nuckle housing and supports the axle and u-joint shaft. On mine it has been peened around the edges of the flange,I assume to hold it in. Is this correct?
Question By: Bob on Dec 7 2011 12:00 AM
This goes on the inside of the spindle itself.
Answer By: Willys Tech on Dec 8 2011 12:00 AM