Questions & Answers
Questions: I installed new wheel bearing with new race, installed new lock nuts and washers. The original outside lock nut is different, it's round and has 3 holes for a tool to remove, with the new nuts I can't install lockers, old nuts are cracked and can't reuse.
Question By: Paul Page on May 16 2017 4:38 PM
Sounds like you have aftermarket lockers. Please call us toll free and we can try to help. Ask for Mike M. Thanks!
Answer By: Willys Jeep Parts Tech on May 16 2017 9:47 AM
Questions: Will these work for the front axle as well?
Question By: James on May 8 2017 1:46 PM
These are for the front axles. They will work for the rear Dana 27 axles as well. Thanks!
Answer By: Willys Jeep Parts Tech on May 8 2017 7:29 AM
Questions: On a Dana 25 , the front spindle has the two washers and locking nuts .. What order and direction do the washers go on .. the diagram looks like the small one goes on and then the big one. if that is correct then does the washer with the little flange face out toward you and bend up after you put the last nut on..
Question By: Anonymous on Feb 19 2015 12:00 AM
Bend the lip of nut lockwasher so that adjustment locknut and lockwasher may be moved. Rotate wheel and tighten the adjusting nut until the wheel binds. Then back off nut about 1/6th turn or more making sure wheel rotates freely without sidewise shake. Replace the lockwasher and locknut and do not fail to bend over the lockwasher lip on nut.
Answer By: Willys Tech on Feb 19 2015 12:00 AM
Questions: Is this the same spindle nut and washers as used on the GPW / MB rear??
Question By: Kerry on Oct 13 2014 12:00 AM
Yes it is the same.
Answer By: Willys Tech on Oct 14 2014 12:00 AM
Questions: Is the outer locking ring available by itself.
Question By: Anonymous on Jan 2 2012 12:00 AM
Sorry these are just sold as kits.
Answer By: Willys Tech on Jan 3 2012 12:00 AM
Questions: Is the material thinner on the outer lock washer allowing it to be bent easier than the original? Is there an alternative lockwasher kit?
Question By: Motthow on Mar 28 2011 12:00 AM
The washer is just like original. They are supposed to be hard to turn over so they dont come loose.
Answer By: Willys Tech on Mar 29 2011 12:00 AM
Questions: where can i find tool for the front spindle nut Item # A867K or which dimension are the tools
Question By: Tom Braathen on May 10 2016 8:48 PM
A692 is the part number you need.
Answer By: Willys Tech on May 11 2016 6:03 AM