Questions & Answers
Questions: Is it normal for these not to hammer in all the way so that they are flush? You can physically see by looking at the free plugs that they are thicker than the hole in the block will allow for. The hole in the block has a bevel at about 1/8 inch and these are 1/4 thick.
Question By: Carmen on May 27 2017 2:33 PM
They should be tapped in for sure and be tight. But I wouldn't say hammered in.
Answer By: Willys Jeep Parts Tech on May 30 2017 5:27 AM
Questions: Hi, will this plug fit on the 6Cyl Super Huracane engine? Regards
Question By: Tony on May 23 2017 1:28 AM
No, I'm sorry but this plug is only for the 4 cylinder. You should be able to match that up locally. Thanks
Answer By: Willys Jeep Parts Tech on May 23 2017 6:13 AM
Questions: How deep are these? The ones I pulled out were only slightly thicker than a coin, these look pretty deep in comparison.
Question By: Lewis on Dec 8 2014 12:00 AM
There are different styles used. They are approx. 1/4 thick.
Answer By: Willys Tech on Dec 9 2014 12:00 AM
Questions: Does the lip/flange go into the body of the engine?
Question By: R D Reeves on Aug 14 2014 12:00 AM
Yes that is correct.
Answer By: Willys Tech on Aug 18 2014 12:00 AM
Questions: How many freeze plugs are in a standard F134 engine?
Question By: Anonymous on Feb 15 2013 12:00 AM
I beleive there are 4.
Answer By: Willys Tech on Feb 18 2013 12:00 AM