Questions & Answers
Questions: Will this replace the airtex 6510 I have on my 1963 wagon with the tornado 230
Question By: Jake Fenner on Feb 26 2019 4:27 AM
No, sorry, this is not for the 6-230 OHC motor.
Answer By: Willys Jeep Parts Tech on Feb 26 2019 5:30 AM
Questions: I live in an area where there is only ethanol-mixed fuel. Is the diaphragm in this pump made of Viton or other ethanol-friendly material?
Question By: Nate on May 9 2018 1:41 PM
Yes, they are made for modern fuel.
Answer By: Willys Jeep Parts Tech on May 9 2018 6:53 AM
Questions: I have a 1961 CJ-5, electric wiper motors. An getting no fuel past pump. Is there anyway to rebuild the pump itself, or better to just buy one?
Question By: Paul on Dec 15 2017 4:27 PM
Your better off getting a new one. I would check your lines and tank for any blockage as well.
Answer By: Willys Jeep Parts Tech on Dec 15 2017 11:12 AM
Questions: My early 1946 CJ-2A (s/n 19786) has the single-stage fuel pump (item # 119239). My reprint of the Willys-Overland Parts List has no mention of a 1/4" spacer between the pump and block; is this spacer necessary for my Jeep to run properly? It seems to do fine without it.
Question By: Joe Partin on Feb 11 2017 8:07 AM
The are used to cut down on pressure. If you are running too much psi I recommend it.
Answer By: Willys Jeep Parts Tech on Feb 13 2017 5:38 AM
Questions: I am considering ordering single action fuel pump119239 to replace mine on my M38A1. I have electric wipers. Do I need to order anything else to install this fuel pump besides the pump itself? Thanks. Tim
Question By: Tim on Jan 16 2017 3:58 AM
You may have to rotate the diaphragm around for front engine plate clearance.
Answer By: Willys Jeep Parts Tech on Jan 16 2017 5:47 AM
Questions: I have a 1957 pickup 6-226 I went to electric wipers witch fuel pump should I use as a replacement. thanks Pappy
Question By: Robert Walls on Nov 17 2016 6:07 PM
735994 is the proper pump for the 6-226 engine.
Answer By: Willys Jeep Parts Tech on Nov 18 2016 5:37 AM
Questions: I have a 1960 CJ-3B with a dual action fuel pump. I am going to a single action pump 119239. Do you have to buy the spacer to use this fuel pump, if the stock pump was the dual action type?
Question By: Micky Fleming on Jul 11 2016 1:03 AM
Typically no but I would double check your fuel pressure after install.
Answer By: Willys Jeep Parts Tech on Jul 11 2016 5:44 AM
Questions: my old fuel pump looks almost like this but the top is differrent. also the topt was slightly turned about an inch sothe fuel linet would miss the brace going over to the motor mount. is it OK to turn the top a little because otherwise the brace is right up against the pump and cannot get fuel line in.
Question By: john alston on Jun 29 2016 8:00 PM
Yes, it is perfectly common to rotate the diaphragm on these for clearance.
Answer By: Willys Jeep Parts Tech on Jun 29 2016 1:03 PM
Questions: You have 2 non vacuum fuel pumps for the F 134 engine. Are there significant differences or advantages in comparison to each. Are both compatable with the new ethanol fuels. Are they American made Thanks Jax
Question By: Fuel pumps for a 1955 CJ 3B on May 5 2016 12:59 AM
The 119238 119240 119239 will all work with the 4-134 engine same as the dual action pump. They just wont have a hook up for vacuum if you don't need it.
Answer By: Willys Tech on May 5 2016 6:08 AM