Questions & Answers
Questions: Willys MB. I understand there are 2 size Clutch plates for the Willys MB. Do you have the smaller size 7.78inch version in stock please not the 8.5 inches? Thank you.
Question By: Laurence on Aug 3 2021 8:27 AM
There was only the 8.5" used on it.
Answer By: Willys Jeep Parts Tech on Aug 3 2021 5:42 AM
Questions: I am need pilot bushing in this?
Question By: Ariel Guinazu on Jun 6 2016 4:54 PM
639578 is the part number for the pilot bushing.
Answer By: Willys Tech on Jun 6 2016 10:45 AM
Questions: I HAVE A 1953 HENRY J WITH THE L 6 CYLINDER WILLIS ENGINE &3 SPEED OD. WILL ITEM# 930731K WORK? THANKS PAUL
Question By: paul norris on May 26 2015 12:00 AM
Yes, as long as you have the 8.5 clutch.
Answer By: Willys Tech on May 27 2015 12:00 AM
Questions: I have a 1943 GPW jeep that I purchased and want to restore which had a buick 6-cyl conversion motor in it when I got it, but running gear is original supposedly. Transmission looks like T84 but the shaft coming out of the front is bigger than a T90 and won't fit into a clutch spline for a Willy;s. Can I change front shaft to a T90 shaft?
Question By: Warren on May 12 2015 12:00 AM
I would double check that you even have a T84 in there still. They may have put a bell housing adapter in there too. Please call us toll free. We can go over options.
Answer By: Willys Tech on May 13 2015 12:00 AM
Questions: I have an M38A1 CDN ('53) with the hurricane 4-134. TM also shows 8.5. Your parts list shows that the 9.5 fits the M38A1. I need to confirm that this kit will work.
Question By: Casey Johle on Dec 16 2014 12:00 AM
The M38A1 could use either the 8.5 or 9.25 clutch. They are not interchangeable. Whatever size you have in there is what size you need to stick with due to mounting pattern on the flywheel.
Answer By: Willys Tech on Dec 16 2014 12:00 AM
Questions: Are you sure this will fit my 453-gb2 . and match up with the original jeep parts.
Question By: tony on Apr 29 2012 12:00 AM
Yes this will work perfectly for you for the vehicles listed above.
Answer By: Willys Tech on Apr 30 2012 12:00 AM