Product Videos
Questions & Answers
Sort By:
Questions: What would be the tallest tire size with this kit on my 1950 m38?
Question By: Jeff Hardee on Jul 8 2018 10:59 PM
You typically don't want to go bigger than a 700 tire which is about 30-1/2" tall. Thanks
Answer By: Willys Jeep Parts Tech on Jul 9 2018 5:21 AM
Questions: Is there any difference between this suspension overhaul kit for the M38 and the one for the CJ3A? I see that they have a different part number, but I can't tell the difference in the two kits. I have an M38 tub on a CJ3A frame.
Thanks!
Question By: Tim on Oct 13 2017 2:27 PM
They use different shackles, leaf springs ect...Please call us toll free and we can help you.
Answer By: Willys Jeep Parts Tech on Oct 13 2017 11:22 AM
Questions: Do you have the greasable shackle bushings? One of them on my M38 CDN has stripped grease nipple thread and several are clogged up and won't accept grease. Should they be replaced or just cleaned?
Question By: Eric Burton on May 30 2017 8:26 PM
802061 & 802062 are the complete shackle with bushing for your Willys M38.
Answer By: Willys Jeep Parts Tech on May 31 2017 5:58 AM
Questions: My 52 M-38 has 10 leafs in front and 11 in the rear. Do you have these available in a kit or individually? I want to keep them the same. thanks.
Question By: Dan on May 30 2013 12:00 AM
We can special order those for you. Please call us toll free. We can help.
Answer By: Willys Tech on May 31 2013 12:00 AM
Questions: I have a 50 m38 and would like to keep the factory height on the suspension but would like a soft ride spring. All of the soft ride kits I've seen have at least 2 inches of lift. Is there one with no lift?
Question By: Anonymous on Oct 2 2011 12:00 AM
Please call me toll free. I can go over your options. This kit is your best bet. It should raise you up approx 1 to 1.5 off what your sitting at now due to your sagging springs. It takes it back to stock height and gives it a good ride again.
Answer By: Willys Tech on Oct 3 2011 12:00 AM
Questions: I've a 1952 M38 Jeep Willys I recently purchased. Unfortunately I never drove it over 30 mph when test driving it. Today, I drove it and at about 32 mph it began to bounce and shake to the point it was hard to keep it on the road. Once I slowed down below 30 mph it was fine. It does not have the original suspension on it. Any suggestions on what may be wrong?
Question By: Dave on Apr 11 2011 12:00 AM
Purchase the steering stabilizer kit we sell. Part number: SJ-7100. It will do the trick.
Answer By: Willys Tech on Apr 11 2011 12:00 AM
You Might Also Be Interested In
Weekly Willys highlights and discounts sent to your inbox
