Questions & Answers
Questions: How can I tell if I have a gear driven crank or a timing chain crank
Question By: Dillan on May 10 2018 1:57 PM
Take the timing cover and see if your gear to gear or have a chain.
Answer By: Willys Jeep Parts Tech on May 10 2018 10:17 AM
Questions: I have two L-134 engines. One is a new casting. One crank shaft has the bolt on counter weights and the other is completely cast. What are the difference between the two and are they interchangeable?
Question By: Kyle Thomas on Feb 9 2018 6:25 PM
They will interchange with each other. Just double check your dowel pins to the flywheel to make sure it matches there.
Answer By: Willys Jeep Parts Tech on Feb 9 2018 11:45 AM
Questions: Are these blocks made in the USA?
Question By: Andy on Jan 7 2018 10:08 PM
These are reground original cranks so yes, they are US made.
Answer By: Willys Jeep Parts Tech on Jan 9 2018 5:56 AM
Questions: 1954 willys jeep works for cj and its weight
Question By: Nelson on Mar 2 2015 12:00 AM
Yes this is correct for all the vehicles listed above.
Answer By: Willys Tech on Mar 2 2015 12:00 AM
Questions: Will the crankshaft from a L 134 that had a timing chain work for a F 134 that has a timing gear
Question By: Anonymous on Oct 12 2012 12:00 AM
Yes, but you will have to drill the oil hole. A crankshaft from any 4-134 gear driven are the same L or F.
Answer By: Willys Tech on Oct 15 2012 12:00 AM
Questions: Is ther any other bolts in the crank to flywheel other than the 2 pins?
Question By: Anonymous on Mar 1 2012 12:00 AM
Also try part number: 632157
Answer By: Willys Tech on Mar 1 2012 12:00 AM
Questions: i have 1953 willys with overhead valve motor what size is it
Question By: rick on Jan 2 2012 12:00 AM
134 cu. in.
Answer By: Willys Tech on Jan 2 2012 12:00 AM
Questions: WIll this crank work in a 134 timing chain motor?
Question By: Mark on May 26 2016 3:47 AM
We can do one that will for you. Please call us toll free.
Answer By: Willys Tech on May 26 2016 6:08 AM
Questions: Do you know the size of standard main and rod bearing surfaces?
Question By: arvid huse on Apr 26 2016 1:27 PM
This varys depending on the crankshaft. They are factory reground and typically come in between .020-.040" u.s.
Answer By: Willys Tech on Apr 27 2016 8:42 AM