Product Videos
Questions & Answers
Sort By:
Questions: On my 1951 jeep station wagon with a Dana 25 front differential I ruined the bronze bushing while removing the oil seal in the inner end of the axle tube next to the carrier bearing. Is this available?
Question By: Charles Davis on Jul 2 2022 5:57 AM
Send me a photo of your old one and I can match up.
Answer By: Willys Jeep Parts Tech on Jul 5 2022 5:52 AM
Questions: With a Bendix should we see the flange or if we cannot does that mean its worn and needs replacing? It looks like it did not have a flange?
Question By: Jonathan Brown on Aug 18 2020 6:19 AM
Some Willys had a flange and some did not. They also do get worn away as well.
Answer By: Willys Jeep Parts Tech on Aug 18 2020 5:51 AM
I believe Bendix used a bushing with no flange. The shims set the axle play. This bushing is for the Spicer U joint held in place with a snap ring on the end of the shaft instead of a nut.
Answer By: Jason Godfrey on Dec 28 2021 4:55 PM
Questions: Can you tell me the OD of the bearing and ID of the spindle, please?
Question By: Joe on Apr 8 2018 7:11 PM
od 1.395 id 1.248
Answer By: Willys Jeep Parts Tech on Apr 9 2018 8:15 AM
Questions: The original bushing in the spindle does not have the flange. With this bushing, will it allow the axle to come forward through the spindle for the proper distance for the flange and shim?
Question By: Eric Hanson on Jul 31 2017 5:44 AM
Your inner lip has most likely worn off. Make sure to full seat this bushing inside the spindle evenly.
Answer By: Willys Jeep Parts Tech on Jul 31 2017 5:42 AM
Questions: Is this the correct one for a 1944 gpw spindle that has spicer axles in it?
Question By: Robert on Jul 2 2014 12:00 AM
Yes that is correct.
Answer By: Willys Tech on Jul 2 2014 12:00 AM
Questions: My bushing look good how do I know if they are worn is there a ID to check this ?
Question By: Bob on Apr 6 2014 12:00 AM
I would check it for out of roundness and scoring.
Answer By: Willys Tech on Apr 7 2014 12:00 AM
Questions: Can it be used with the Bendix type of axle shaft?
Question By: Robert on Apr 9 2013 12:00 AM
Yes it can.
Answer By: Willys Tech on Apr 9 2013 12:00 AM
Questions: I assume this bushing goes into the nuckle housing and supports the axle and u-joint shaft. On mine it has been peened around the edges of the flange,I assume to hold it in. Is this correct?
Question By: Bob on Dec 7 2011 12:00 AM
This goes on the inside of the spindle itself.
Answer By: Willys Tech on Dec 8 2011 12:00 AM
You Might Also Be Interested In
Weekly Willys highlights and discounts sent to your inbox
