Questions & Answers
Questions: If I have to remove the brass bushing. Which one do I put in it?
Question By: Chase D Crum on Apr 17 2022 8:32 PM
Answer By: Willys Jeep Parts Tech on Apr 18 2022 5:52 AM
Questions: Are these spindles new?? or nice used??
Question By: Jerry Harms on Feb 24 2021 2:23 AM
These are new.
Answer By: Willys Jeep Parts Tech on Feb 24 2021 5:34 AM
Questions: do they make shims for the spindle to knuckle mounting area ,I put the new axle shafts in and there is zero end play
Question By: rob fisher on Aug 21 2019 5:54 PM
No not spindle to knuckle. I do have them at the drive flange part number A862
Answer By: Willys Jeep Parts Tech on Aug 21 2019 11:28 AM
Questions: Mike, do you have a part number for the paper gasket that goes between the spindle and the steering knuckle?
Question By: kyle Thomas on Jan 7 2019 12:31 AM
That i would use some sealant on.
Answer By: Willys Jeep Parts Tech on Jan 7 2019 5:43 AM
Questions: I need to mount a large ships wheel (4 foot diameter, 60 lbs) to a concrete fireplace and this spindle looks ideal. What is the diameter of the shaft? The ship wheel bore is 1.500, +/- 0.010. I am a machinist so I can open wheel bore if necessary.
Question By: David on Jul 9 2017 1:31 PM
Call us toll free and we can see what you need and we can help.
Answer By: Willys Jeep Parts Tech on Jul 10 2017 6:08 AM
Questions: The spindle shown appears to come with the brass bushing installed. Is this a correct assumption?
Question By: William Schmidt on Sep 19 2016 6:30 PM
yes, that is correct.
Answer By: Willys Jeep Parts Tech on Sep 19 2016 12:16 PM
Questions: Is there supposed to be a paper seal between this part and part number 805783 (knuckle)...thanks, Curt
Question By: Curt on Jun 13 2014 12:00 AM
We can now get them in NEW.
Answer By: Willys Tech on Jun 25 2014 12:00 AM
Questions: I got a spindle bushing from you and i was wandering how tight the axle is supposed to be. I installed the new bushing and I cant turn it with my bare hands, did I do something wrong? Or is it supposed to be tight like that?
Question By: Anonymous on Sep 14 2011 12:00 AM
Rotate the wheel and tighten the adjusting nut until the wheel binds while on jacks. Then back off nut about one-sith turn or more if necessary making sure that the wheel rotates freely without sidewise shake.
Answer By: Willys Tech on Sep 14 2011 12:00 AM
Questions: Do these spindles have scored surfaces or wear on the outside of the shaft from previous use?
Question By: Marty on Jun 26 2011 12:00 AM
No we try to only ship out good used one.
Answer By: Willys Tech on Jun 27 2011 12:00 AM