Questions & Answers
Questions: Mike, I have a 1957 CJ5 onto which I just installed a Koenig PTO and winch. The exhaust pipe had to be cut for the winch driveshaft and I am looking for a solution. I understand that one solution is to install the MB exhaust system to run the exhaust to the passenger side to avoid running the exhaust under the cross member and putting it in harm’s way. Do y’all have any other suggestions?
Question By: Albert Leddy on Jun 4 2019 9:15 PM
I think the best way would be to modify your long pipe for clearance but yes, I have heard of a MB kit working as well with modification as well.
Answer By: Willys Jeep Parts Tech on Jun 5 2019 5:33 AM
Questions: I have a CJ2a which I've mostly "made" into an MB-clone. The current civilian exhaust exists rear of the frame. I'm looking to replace it with something appropriate to an MB which exits right passenger side. Do you know whether this would be suitable?
Question By: Doug on Dec 19 2017 12:19 AM
Im sure this kit could be used with some modification to suit your needs.
Answer By: Willys Jeep Parts Tech on Dec 19 2017 5:46 AM
Questions: Do you have an exhaust system for a 1969 cj5 6 cyl
Question By: Al Anton on Oct 17 2014 12:00 AM
When you have the V6-225 you have to make your exhaust locally.
Answer By: Willys Tech on Oct 20 2014 12:00 AM
Questions: I have an early civilian CJ2A with the tool indentation body. Would this be the proper exhaust system for my Jeep?
Question By: Anonymous on Dec 1 2011 12:00 AM
If you have a CJ-2A You will need to use the civilian exhaust system or be original. However this may work...
Answer By: Willys Tech on Dec 2 2011 12:00 AM
Questions: The body/frame of my Jeep is a 44MB, turns out the engine is out of a 47 CJ-2A. Would this kit still work or should I be looking at the CJ-2A kit?
Question By: Vito on Aug 26 2011 12:00 AM
This should still work just fine for you.
Answer By: Willys Tech on Aug 26 2011 12:00 AM