Questions & Answers
Questions: Does these have the threaded ends.?
Question By: Daryl on Aug 11 2019 1:58 PM
Yes, it has the threaded end on it.
Answer By: Willys Jeep Parts Tech on Aug 12 2019 5:57 AM
Questions: I have a Dana 25 front axle. The short side is a Rzeppa with screws to take it apart. The long side looks like a Rzeppa axle BUT has no screws to take it apart. Can you tell me how this side comes apart and is this also a Rzeppa axle?
Question By: Bob Dobis on Feb 8 2015 12:00 AM
Yes this is a Rezeppa. Im not sure what you mean by screws to take it apart. You may be looking at an aftermarket lockout on your vehicle.
Answer By: Willys Tech on Feb 9 2015 12:00 AM
If You have the jeep service manual (reprinted available from K/W) look at section M-8. If the cage retainer does not have the three little screws, you drive the shaft inward using a wood mallet if necessary to drive the retaining ring into its groove in the spline, permitting the joint to be slipped off the axle shaft. Mine had the 3 screws on both sides thankfully, but I can see this should work. Cheers, Tom
Answer By: Tom Wright on Nov 20 2018 6:08 PM
Questions: Will this axle fit in a 1952 M38A1 with out changes to the spindle bushing , and do I have to put a nut or snap ring to hold it to the flange at the end of the hub assembly. Im replacing worn out bendix axles .
Question By: Ernest on Feb 4 2014 12:00 AM
Yes this is for all the vehicles listed above. These take a castle nut and cotter pin at the end of the shaft.
Answer By: Willys Tech on Feb 5 2014 12:00 AM
Questions: Hi , on stripping the front axle i see the the side shafts are not the same the short side is the Bendix type and the long is the Rzeppa type ,what should it be? My jeep is a 1949 CJ2A Please advise
Question By: PatHi on Mar 30 2013 12:00 AM
One your CJ-2A someone has replaced an axle thru the years. It is common. Both were originally the Rezeppa style. They are interchangable either way.
Answer By: Willys Tech on Apr 1 2013 12:00 AM