Product Videos
Questions & Answers
Sort By:
Questions: So I replaced this part last year along with the knuckle arm because the studs kept stripping and breaking on the original. I figured the arm would be a tight fit on the studs, no play to get worse. The fit was just as loose on the new parts as the old. I installed new knuckle, arm and studs, tightened up nicely. Happened to be working on brakes today, grabbed the wheel and it's all loose again! Is there a one piece unit available that would fit? The driver side has been fine since '42...
Question By: Tom Elbert on May 16 2022 6:40 PM
These are NOS originals. You probably need to check your king pin bearings, wheel bearings and spindle nuts too.
Answer By: Willys Jeep Parts Tech on May 16 2022 12:39 PM
Questions: What is the difference between this part and your 805784 knuckle support? Can you use the 805784 to replace the A811?
Question By: John on Apr 6 2015 12:00 AM
No problem the MB/GPW used a different set than later CJ's. They are not interchangeable.
Answer By: Willys Tech on Apr 7 2015 12:00 AM
Weekly Willys highlights and discounts sent to your inbox
