Questions & Answers
Questions: is their a video on how to install a rear axle outer bearing cone (52799) onto the axle from start to finish and what tools you need.
Question By: GRAHAM JONES on Oct 15 2019 12:59 AM
I dont have a video but can help answer any questions. Please email firstname.lastname@example.org and we can help. For sure you will need part number: HP600 puller.
Answer By: Willys Jeep Parts Tech on Oct 15 2019 6:27 AM
Questions: How do I remove the rear wheel bearings ?
Question By: Mike on Oct 21 2017 12:06 AM
They will come off with your rear axle shaft when you pull it. Alot of times you will need a puller. Then to get bearing off, use a press.
Answer By: Willys Jeep Parts Tech on Oct 23 2017 5:47 AM
Questions: What is the bore diameter?
Question By: Colin Bartlett on Feb 2 2017 5:56 PM
Its is approx. 1.35-1.365 like original at the ID.
Answer By: Willys Jeep Parts Tech on Feb 2 2017 11:02 AM
Questions: Do these bearings come with the press fit bearing retainers for the flanged axles?
Question By: Anonymous on Nov 21 2014 12:00 AM
I think you mean the race part number: 52800
Answer By: Willys Tech on Nov 24 2014 12:00 AM
Questions: How many wheel bearings do i have do buy?
Question By: Jose Costa Pinto on Nov 6 2012 12:00 AM
You will need two of these for your rear end. One for each wheel.
Answer By: Willys Tech on Nov 6 2012 12:00 AM
Questions: I'm looking for wheels bearings for Dana 44. Do these bearing cones for wheels?
Question By: Jose Costa Pinto on Nov 3 2012 12:00 AM
Yes these are the right ones. Also use part number: 52800
Answer By: Willys Tech on Nov 4 2012 12:00 AM
Questions: Since the axle bearings are lubricated with the differential oil do these wheel bearings need to be packed with wheel bearing grease before they are reinstalled?
Question By: grizadams on Jun 4 2012 12:00 AM
Yes, always pack your bearings prior to install with heavy duty axle grease.
Answer By: Willys Tech on Jun 5 2012 12:00 AM
Questions: whats the best way of getting the old ones off from the axle shaft? do they just pop out or what?
Question By: Anonymous on Jun 20 2011 12:00 AM
You need an axle shaft puller to get them out from the axle housing tube with the axle shaft.
Answer By: Willys Tech on May 26 2016 11:04 AM