Questions & Answers
Questions: What kind of gasket sealer, if any, do you use on the cork oil pan gasket, and where should it be applied? Whole gasket or just parts of it?
Question By: Marshall Hewitt on Jul 25 2016 8:29 PM
You don't have to but I would recommend a good automotive gasket sealer. Your local napa will have it. Just a thin layer between holes.
Answer By: Willys Jeep Parts Tech on Jul 25 2016 1:32 PM
Questions: I need to replace this gasket on my 1946 cj2a, to what torque do the bolts on the oil pan need to be tightened to on the L-134 engine?
Question By: Nick on Mar 4 2014 12:00 AM
The book doesnt specify a spec. Just tighten to make make seal. Dont over torque.
Answer By: Willys Tech on Mar 4 2014 12:00 AM
Questions: what is this gasket made of, is it made of polypropylene, do they make one from polypropylene?
Question By: Mike Sharpe on Mar 2 2013 12:00 AM
This is a cork gasket. It will do the trick for you.
Answer By: Willys Tech on Mar 4 2013 12:00 AM
Questions: I need to replace the pan gasket on my 1959 CJ5. Do I have to pull the engine to remove the pan ?
Question By: Jim Welch on Apr 17 2012 12:00 AM
No you just have to unbolt the oil pan. Lowering all the bearing caps is recommended.
Answer By: Willys Tech on Apr 17 2012 12:00 AM
Questions: Does this come with oil plug crush washer or the gasket for the oil float?
Question By: Anonymous on Dec 28 2011 12:00 AM
No, those you will have to make.
Answer By: Willys Tech on Dec 29 2011 12:00 AM
Questions: Is this gasket cork that is what i am looking for
Question By: Jerry on Dec 1 2011 12:00 AM
Yes that is correct. Just like original.
Answer By: Willys Tech on Dec 1 2011 12:00 AM