Questions & Answers
Questions: Is this wire set close to the original wires that came on the vehicle? Thanks.
Question By: Weldon Clinard on Apr 1 2022 3:19 PM
Yes proper USA made wire set.
Answer By: Willys Jeep Parts Tech on Apr 4 2022 5:32 AM
Questions: Do you have to add anything to the ends or are these a direct plug in to the distributor cap?
Question By: Vincent on Feb 5 2021 6:02 PM
They are ready for install.
Answer By: Willys Jeep Parts Tech on Feb 5 2021 10:27 AM
Questions: Are these solid core wires or resistor type wires?
Question By: Oliver on Feb 14 2019 4:50 PM
Answer By: Willys Jeep Parts Tech on Feb 19 2019 6:19 AM
Questions: Will these work with electronic ignition modules that replace the points and condenser?
Question By: Joe Nichols on Jun 11 2018 4:40 PM
Yes, these should.
Answer By: Willys Jeep Parts Tech on Jun 12 2018 6:03 AM
Questions: What are the brass tacks? How do you install without crimps?
Question By: Tom Sage on May 23 2015 12:00 AM
Those just stick thru the end of the cable and crimp in place. They are the contacts.
Answer By: Willys Tech on May 26 2015 12:00 AM
Questions: Since I'm going 12 volt do I need a shorter coil to distributor wire than the original wire that came from the dash mounted coil?
Question By: Anonymous on May 12 2015 12:00 AM
You will want to mount your coil on your block next to the distributor on the existing studs that are there. If your missing the bracket its part number: MSD8213
Answer By: Willys Tech on May 12 2015 12:00 AM
Questions: I have a dash mounted Keyed coil. Do you have a coil wire that would be long enough to reach that?
Question By: Anonymous on Mar 29 2012 12:00 AM
You are probably going to have to pick up the suppression wire locally. Typically you can buy it in universal lengths.
Answer By: Willys Tech on Mar 30 2012 12:00 AM
Questions: How can I shorten the suppression cables for my flat head 134 ? They seem to be much longer than my current old ones.
Question By: Robert on Aug 27 2011 12:00 AM
Yes these can be trimmed.
Answer By: Willys Tech on Aug 29 2011 12:00 AM
Questions: what is the firing sequence of the CJ-3A and the CJ-2A
Question By: ned jones on Aug 9 2011 12:00 AM
Answer By: Willys Tech on Aug 9 2011 12:00 AM
Questions: Are they angled or straight? The description says they have the proper 90 degree angle but the photo shows them as being straight.
Question By: mike on Feb 5 2011 12:00 AM
The image is going to be updated. They have the proper 90 degree bend on them.
Answer By: Willys Tech on Feb 7 2011 12:00 AM