Product Videos
Questions & Answers
Sort By:
Questions: Will the A-1198-ST work with a Buick 6 cylinder engine? If not, what would?
Thank you,
thomas
Question By: Thomas Rice on Aug 30 2019 9:14 PM
No, this is only for the flat head 4-cylinder engine. You'll have to make one up for the V6 engine. Thanks
Answer By: Willys Jeep Parts Tech on Sep 2 2019 2:18 PM
Questions: Is there a hose that attaches to the steel oil pressure line and the block? I bought the gauge and the steel line but the line is too short.
Question By: Don Stipech on Nov 24 2017 4:35 PM
Yes, there is. Order part number - A1198. Thanks
Answer By: Willys Jeep Parts Tech on Nov 24 2017 10:30 AM
Questions: Is there a grommet that goes in the firewall that the steel line goes thru?
Question By: Gary C Lindberg on Sep 7 2017 2:45 AM
Yes, they used a grommet thru there. See part number: B1843
Answer By: Willys Jeep Parts Tech on Sep 7 2017 5:45 AM
Questions: Will this fit a 53 M38A1? Thanks.
Question By: Nick on Apr 2 2015 12:00 AM
This is only for the vehicle listed above.
Answer By: Willys Tech on Apr 3 2015 12:00 AM
Questions: I have a 42 gpw with a buick 225 v6 - will this part work for me?
Question By: thomas on Jan 1 1970 12:00 AM
It will screw into the back of your gauge like original.
Answer By: Willys Tech on Nov 24 2014 12:00 AM
Questions: Where on the engine does this line attach? thanks.
Question By: Frank on Aug 18 2014 12:00 AM
There is a lower galley plug on the bottom drivers side rear corner of the block.
Answer By: Willys Tech on Aug 19 2014 12:00 AM
Questions: do you have the rubber hose that goes between the engine and this steel line?
Question By: t yates on Jan 14 2014 12:00 AM
A1198 is the part number for the flex line.
Answer By: Willys Tech on Jan 15 2014 12:00 AM
Questions: I have a 1953 M38A1- will this fit or do you have a steel line that will. I have an after market plastic hose replacement gage in the dash now and am going to replace it with a proper gage which calls for the steel line to the sending unit.
Question By: C G BROWN on Jan 2 2013 12:00 AM
For the M38A1 you will have to make it. Your local Napa does sell preflared steel lines in different lengths you can bend up.
Answer By: Willys Tech on Jan 2 2013 12:00 AM
Questions: Will this work on a 1951 M38? It has a L-134 engine. 12 volt, not the original. I know the manual oil pressure gauge will work. I will not be using the 24 volt gauge that the M38 had originally.
Question By: Don on Jan 1 1970 12:00 AM
Yes im sure it would work just fine. You may just have to get adapter fittings at your local NAPA.
Answer By: Willys Tech on Nov 28 2012 12:00 AM
Weekly Willys highlights and discounts sent to your inbox
