Questions & Answers
Questions: What size steering shaft will this bushing fit? Thanks, Jeremy
Question By: Jeremy Mang on Nov 5 2021 5:49 PM
See the fits information on the tube and worm gears it fits.
Answer By: Willys Jeep Parts Tech on Nov 8 2021 5:34 AM
Questions: Is there a hole in the steering shaft that the horn wire goes through? I cannot figure out how I am supposed to solder this wire.
Question By: Jason on Mar 21 2021 4:54 PM
Yes, that is correct. Email firstname.lastname@example.org and we can hep out with some diagrams.
Answer By: Willys Jeep Parts Tech on Mar 22 2021 5:48 AM
Questions: what is the trick for soldering the horn wire to this brass bushing?
Question By: Randy Butler on Feb 23 2021 5:26 PM
Don't get it too hot. you don't want the rubber insulation to melt away and create contact.
Answer By: Willys Jeep Parts Tech on Feb 23 2021 10:31 AM
Questions: How do you remove the old Steering column horn contact bushing cj2a 1949
Question By: Ray on May 31 2018 11:51 PM
It is on there tightly and we usually cut them off if you can get it to slide off.
Answer By: Willys Jeep Parts Tech on Jun 1 2018 5:43 AM
Questions: 1946 Kaiser Willys CJ2A- the grooved insert within the steering wheel is stripped, as is the shaft to receive the wheel. Will this product help me? if not, any suggestions.
Question By: Karla on Apr 8 2017 7:17 PM
Sounds like you need a new steering wheel part number: 914047
Answer By: Willys Jeep Parts Tech on Apr 10 2017 5:47 AM
Questions: What is the inside and outside diameters of this product. I'm looking to use it in a different application. Thank you.
Question By: Bruce Martin on Nov 24 2016 5:04 PM
The ID is 78". The OD is 1". And the overall length is 7/8". Thanks
Answer By: Willys Jeep Parts Tech on Nov 27 2016 11:27 AM
Questions: What is the trick to sliding this down a new inner steering tube it is to tight of a fit??
Question By: Bill Daybrest on Jun 10 2016 7:59 PM
It will be very tight going down. A lot of times you will need to take just a tad off the ID of the rubber to get it to go down.
Answer By: Willys Jeep Parts Tech on Jun 13 2016 5:53 AM