Questions & Answers
Questions: Do these fit over the straight axel hubs?
Question By: John Marking on Apr 3 2022 2:45 AM
See information on what all vehicles these fit.
Answer By: Willys Jeep Parts Tech on Apr 4 2022 5:35 AM
Questions: What holds the dust cover on, does it clip over the washer between the nut, I have a dana44 rear axle in my CJ2A jeep
Question By: Butch on Mar 27 2022 9:17 PM
It is tapped into place on a slip fit.
Answer By: Willys Jeep Parts Tech on Mar 28 2022 5:58 AM
Questions: Will these fit a 1958 fc150?
Question By: Ted Rihely on Apr 21 2021 1:14 AM
Yes, that is correct.
Answer By: Willys Jeep Parts Tech on Apr 21 2021 5:31 AM
Questions: I have a cotter pin in the rear axle nut of my 47 CJ2a. Should I remove it or bend the pin to make it fit so that the dust cover fits over? Is the dust cover gently hammered on to install?
Question By: Howard on Jan 20 2021 4:53 AM
Dont remove the cotter pin. Its there to keep the nut on. You just bend and put the dust cover on.
Answer By: Willys Jeep Parts Tech on Jan 20 2021 5:31 AM
Questions: I ordered both these and and the rear axle washer for a Dana 44 tapered, however the dust cover does not fit over the washer. Am I missing something? Thanks in advance!
Question By: Jeffrey on May 17 2019 12:34 PM
Please take a picture of your washer you are using. You can email firstname.lastname@example.org
Answer By: Willys Jeep Parts Tech on May 17 2019 9:06 AM
Questions: Does the hub dust cover fit over the 4-wheel drive axle component that extends out from the wheel in front? In the picture it doesn't appear large enough.
Question By: Samuel on Nov 12 2013 12:00 AM
Yes this is the proper dust cover for the original drive flanges in the front and hubs in the rear.
Answer By: Willys Tech on Nov 12 2013 12:00 AM
Questions: What is the measurement of the dust cover? Do they fit over the the entire 4wd hob (approx 4 1/4) or just the center part (about 2)?
Question By: Larry Murdock on Jul 13 2011 12:00 AM
These fit over just the center part just like original.
Answer By: Willys Tech on Jul 13 2011 12:00 AM