Questions & Answers
Questions: Does this come with all the gaskets and seals needed?
Question By: Chase on Aug 20 2019 5:49 AM
This is the flange only. If you need a gasket and seal seat for your Dana 18 see part number: 923300
Answer By: Willys Jeep Parts Tech on Aug 20 2019 5:35 AM
Questions: Can you tell me the measurement across from spline to spline. Need it for another application. My shaft measures about 1 and 1/8 inches. Also measurement from outside part is( where the spline s are. And the length of the spline part only
Question By: Mike on Feb 27 2019 4:41 AM
Please email firstname.lastname@example.org and I can get clarification for you on measurement.
Answer By: Willys Jeep Parts Tech on Feb 27 2019 5:34 AM
Questions: if i replace the flange with a new one do i have to adjust the bearing preload
Question By: scott breden on May 2 2017 1:12 AM
You would want to check it to make sure its back to factory spec backlash.
Answer By: Willys Jeep Parts Tech on May 2 2017 6:15 AM
Questions: The tag on my transfer case says the manufacturer was Spicer, not Dana. The serial # is J 257259, the model # is 18. Is your part # 116714 (rear output companion flange) the correct part for this application? I also need the corresponding seal, (victor # 49372), is this the same as your part # 923896?
Question By: Anonymous on Apr 23 2013 12:00 AM
Spicer made the Dana 18. Yes these will all be correct for you.
Answer By: Willys Tech on Apr 23 2013 12:00 AM