Questions & Answers
Questions: What size and type of fittings can be used to connect the dual action fuel pump for the 6-226 ?
Question By: Brett Frantz on Apr 2 2020 2:11 AM
A200 is the part number for the fitting.
Answer By: Willys Jeep Parts Tech on Apr 2 2020 6:00 AM
Questions: Hi, I just installed electric wipers on my 1962 Jeep Pickup. With the 226 engine. Should I just put a plug in the vacuum port in the fuel pump? Also, do they make a single action fuel pump for this engine? Thanks.
Question By: Larry on Dec 8 2019 8:30 PM
I wouldnt plug it. If you are not using the other port I would runt a line between them.
Answer By: Willys Jeep Parts Tech on Dec 9 2019 5:28 AM
Questions: When installing a dual action fuel pump, what size drill and tap should I use to connect the vacuum side to the wipers?
Question By: Harold Estes on Sep 11 2019 8:53 PM
These are already ported for your vacuum fittings. You dont need a drill or tap.
Answer By: Willys Jeep Parts Tech on Sep 12 2019 6:00 AM
Questions: Hi, I need the fuel pump dual acction for Willys 1957, stake model, six cylinder. Thank you.
Question By: Enrique on Aug 22 2019 9:07 PM
OK, this will be the correct one for you 6-226 motor.
Answer By: Willys Jeep Parts Tech on Aug 26 2019 5:34 AM
Questions: I just bought my dads 54 pickup with the 6-226. The vacuum side of the pump had lines that were connected to the rear of the crankcase and the other side connected to the back of the carburetor near the base. In that line there was some sort of regulator before the carburetor fitting. The wiper assembly was converted to electric years ago, so can I just remove the vacuum lines and loop them together? or a single action pump with a glass bowl be added? He has had issues with this truck for years and added an electric fuel pump to the system. Your thoughts?
Question By: Andrew Swick on Jul 24 2019 11:31 PM
Typically you would see a PCV valve inline. I would make sure you have some way to vent your crankcase if your going to do this.
Answer By: Willys Jeep Parts Tech on Jul 25 2019 5:49 AM
Questions: I have two questions: 1st. I have a 1959 Willy’s Wagon 6-226 how do I know if it is a a 6-226L? 2nd my wipers have been converted to electric, can I still use this fuel pump? If so should the plug the vacuum? Thank you
Question By: Michael West on Nov 4 2018 4:27 PM
You cant plug the vacuum. You have to a least port them together. Take some photos and email email@example.com and I can ID your motor.
Answer By: Willys Jeep Parts Tech on Nov 5 2018 11:50 AM
Questions: Do you offer fuel pump rebuild kits, such has the diaphragms and gaskets for the L6-226?
Question By: Chris Freidhof on May 14 2018 1:22 PM
Sorry, i can only get complete pumps.
Answer By: Willys Jeep Parts Tech on May 14 2018 9:25 AM
Questions: Hi What fuel lines do I need for the pump for my 1962 truck? Thanks
Question By: anita on Nov 25 2017 12:37 AM
No one makes the fuel lines for the Trucks or Station Wagons. You'll have to go locally and buy and pre-flarred lines and bend them to fit.
Answer By: Willys Jeep Parts Tech on Nov 27 2017 5:47 AM
Questions: My old pump has a pump lever with a slide on it. I see from the pictures that your pump does not have a slide on the lever. Will this be a problem?
Question By: Steve Dickerson on Aug 20 2017 2:08 AM
No, that would just be a primer handle. It wont be a problem.
Answer By: Willys Jeep Parts Tech on Aug 21 2017 5:40 AM
Questions: Does this fuel pump come with the gasket?
Question By: Matthew Egan on Apr 10 2017 2:49 AM
Yes, it does.
Answer By: Willys Jeep Parts Tech on Apr 10 2017 5:52 AM
Questions: What does the dual action vacuum run?
Question By: Kyle Joseph Waletich on Mar 3 2017 2:10 PM
Typically your vacuum wiper motor and dist. chamber.
Answer By: Willys Jeep Parts Tech on Mar 3 2017 6:20 AM
Questions: I have a 6-226 flathead and I replaced the fuel pump over 1 year ago. Have had problems with it stalling after it warms up and not starting. thought it was the carb. replaced fuel tank,fuel lines,rebuilt carb,replaced fuel filter. Could the fuel pump be defective? It cranks up cold with the choke pulled out and runs but when warm,upon shutting off motor will not start back until it cools. I have checked timing, points, condenser,coil, no change.I do not use the vacume wipers,should it be plugged
Question By: glen roseboro on Jul 26 2013 12:00 AM
Alot of times you will find the carburetors will drain if you dont run them only every so often. When starting the vehicle you need to pump the accelerator pedal several times (not enough to flood) to get enough fuel back into the bowl.
Answer By: Willys Tech on Jul 26 2013 12:00 AM
Questions: I have a 1953 with F head 6. It has a Carter fuel pump that looks different from the picture which states it is for 1954 model. Will this pump work on '53. Looks like it will need fuel lines re-routed. I was trying to keep original.
Question By: Ken Drill on Jun 1 2013 12:00 AM
This engine is a 6-226 L head. Sounds like you may have a 6-161 F head engine. That would be part number: 119482
Answer By: Willys Tech on Jun 3 2013 12:00 AM
Questions: Will this pump work on a 1957 FC170 6-226?
Question By: Tray on Apr 11 2013 12:00 AM
Yes that is correct. It is for all 6-226 engines.
Answer By: Willys Tech on Apr 15 2013 12:00 AM
Questions: Item # 735994...Will this fit a 230 tornado motor in a 1963 Willys truck. I have a dual action fuel pump on mine that runs the wipers. I bought a single action because I didn't realize the wipers run off the top side.
Question By: Anonymous on Feb 19 2013 12:00 AM
Part number: 930144 is the pump you want for the 6-230 OHC engine. This is for the 6-226 L head engine.
Answer By: Willys Tech on Feb 20 2013 12:00 AM
Questions: Do you guys fix fuel pumps thank you.
Question By: Pedro Lomeli on Jan 19 2012 12:00 AM
We typically rebuild the military fuel pumps and we have all the civilian available new.
Answer By: Willys Tech on Jan 20 2012 12:00 AM