Rear Output Companion Flange
Fits 41-71 Jeep & Willys with Dana 18 transfer case

More Views

Rear Output Companion Flange
Fits 41-71 Jeep & Willys with Dana 18 transfer case
New Rear Output Companion Flange (1 required per vehicle)

For all vehicles with rear transfercase mounted emergency brake setup.

Dana 18 Transfercase

41-45 MB
41-45 GPW
46-49 CJ-2A
49-53 CJ-3A
53-64 CJ-3B
55-71 CJ-5
50-52 M38
52-66 M38A1
46-64 Truck
46-64 Station Wagon
Item # Price

Availability: In stock

Add to Wishlist

Product Videos

Questions & Answers

Sort By: 


Questions: I do not have "rear transfer case mounted emergency brake setup" as specified above. My current yoke is similar to the front item A1106, but has old Cleveland style geometry. I am currently replacing my rear driveshaft to modernize to 1310 style U joints. Will the A1106 fit on the rear output shaft of the transfer case and is it compatible with 1310 U joints?
Question By: Jim Willingham on Apr 28 2020 2:20 PM
If you can please email some images of what all you have and set up and we can help. Thanks!
Answer By: Willys Jeep Parts Tech on Apr 28 2020 10:54 AM
Questions: Does this come with all the gaskets and seals needed?
Question By: Chase on Aug 20 2019 5:49 AM
This is the flange only. If you need a gasket and seal seat for your Dana 18 see part number: 923300
Answer By: Willys Jeep Parts Tech on Aug 20 2019 5:35 AM
Questions: Can you tell me the measurement across from spline to spline. Need it for another application. My shaft measures about 1 and 1/8 inches. Also measurement from outside part is( where the spline s are. And the length of the spline part only
Question By: Mike on Feb 27 2019 4:41 AM
Please email and I can get clarification for you on measurement.
Answer By: Willys Jeep Parts Tech on Feb 27 2019 5:34 AM
Questions: if i replace the flange with a new one do i have to adjust the bearing preload
Question By: scott breden on May 2 2017 1:12 AM
You would want to check it to make sure its back to factory spec backlash.
Answer By: Willys Jeep Parts Tech on May 2 2017 6:15 AM
Questions: The tag on my transfer case says the manufacturer was Spicer, not Dana. The serial # is J 257259, the model # is 18. Is your part # 116714 (rear output companion flange) the correct part for this application? I also need the corresponding seal, (victor # 49372), is this the same as your part # 923896?
Question By: Anonymous on Apr 23 2013 12:00 AM
Spicer made the Dana 18. Yes these will all be correct for you.
Answer By: Willys Tech on Apr 23 2013 12:00 AM