Questions & Answers
Questions: Are these original to a gpw? my frame has no holes for them.
Question By: mark on Jun 3 2014 12:00 AM
Yes, the early Willys had them as well.
Answer By: Willys Tech on Jun 4 2014 12:00 AM
Questions: On June 5th, 2011, Bradley asks if the Snubber is solid rubber or the bottom metal plate coated in rubber. The answer given was, yes that's correct. Which answer is correct? I am assuming that it's metal coated in rubber.
Question By: Jim on Jan 26 2013 12:00 AM
There is a metal bottom plate that is the base. It is coated in rubber as well.
Answer By: Willys Tech on Jan 28 2013 12:00 AM
Questions: On my Cj2a there are two cast iron blocks bolted to the bottom of the frame above the rear axle. They are about 1 thick and they have a stamped sheet metal plate on the block with the remains of a rubber bumper in it. Does this part fit with this arrangement?
Question By: Bob on Feb 23 2012 12:00 AM
Yes these will line up with your spacer too.
Answer By: Willys Tech on Feb 23 2012 12:00 AM
Questions: Are these solid rubber, or is the bottom plate metal coated in rubber?
Question By: Bradley on Jun 5 2011 12:00 AM
Yes that is correct.
Answer By: Willys Tech on Jun 6 2011 12:00 AM
Questions: will these fit on my 1964 FC 170?
Question By: Gary Conklin on Feb 4 2011 12:00 AM
Yes, this should work for you.
Answer By: Willys Tech on Feb 7 2011 12:00 AM
Questions: I have a 47 cj2a and need two of these for the front frame above the axle, will these fit?
Question By: Bob Appleman on May 17 2016 11:11 PM
Yes, it fits all the vehicles listed above.
Answer By: Willys Tech on May 18 2016 6:15 AM
Questions: 1) Do the bolts that hold these on have nuts on the back (inside the frame) or do they just screw into the frame? 2) What is the distance between the bolt holes? Thanks!
Question By: Tom on May 17 2016 5:43 PM
On most vehicles the frame was tapped for them. They are approx. 4" c to c like original.
Answer By: Willys Tech on May 17 2016 11:15 AM