Product Videos
Questions & Answers
Sort By:
Questions: I need to replace the speedo cable on my 62 SW with the 226 straight 6. what one is correct for me ?
Question By: Jamie on Mar 18 2021 8:04 PM
Yes, that is right 643797A is the same.
Answer By: Willys Jeep Parts Tech on Mar 18 2021 1:53 PM
Questions: I’m running a D18 transfer case And the speedo seems to be getting Transfer Case fluid oggered up through the t-case and leaks are the speedo. The cable I have is the grey shielded one with the 1” barrel but at the t-case. Is this a common issue? Is the cable core wrapped backward? It’s perplexing.
Question By: Frank on Jan 28 2020 1:32 AM
Sounds like your transfer case may be just a bit overfilled or more likely you dont have the vent installed at the top of the housing of the D18 part number: A934 and it s building pressure. They never used a seal there.
Answer By: Willys Jeep Parts Tech on Jan 28 2020 6:10 AM
Questions: I'm replacing a speedo cable that is currently 90% missing altogether. Which end fits in the speedo and which the transfer case. Long Prong goes in which? Hope that makes sense. '47 CJ2a
Question By: Mike Hauser on Jan 6 2020 9:20 PM
The inner cable should be equalized in the outer cable so equal parts go into each end. When you go to screw it in- you'll see the fittings on each end and their mate.
Answer By: Willys Jeep Parts Tech on Jan 7 2020 6:11 AM
Questions: on the hex nut (transfercase) end does it come with gasket, one picture looks like it if not do you have it available
Question By: Richard Lacy on May 7 2019 2:56 PM
No there is no gasket with it. We usually use alittle sealant. But really your fill level is not that high.
Answer By: Willys Jeep Parts Tech on May 7 2019 8:48 AM
Questions: This cable seems to be a little too long for my 1965 cj5. The outer cable is fine, but the inner cable seems too long. It will not insert into the speedo head enough to allow the end to catch the threads. I have checked at the trans. and it seems to be inserted as far as it will go, about a half an inch. It just does not insert into the head enough to allow the screw to start. Can the inner cable be trimmed? thanks
Question By: bill on Apr 8 2018 3:48 AM
It is correct. Make sure the inner cable is equalized between both speedo head and transfer case. Call me toll free. Mike M. and we can try to help too.
Answer By: Willys Jeep Parts Tech on Apr 9 2018 5:47 AM
Questions: I'm a little confused. What's the difference between this cable and the $99 cable also shown for this year model range?
Question By: Doug Lewis on Oct 18 2017 3:37 PM
The military cable had a inner tab on the end of the cable. They are not interchangeable with each other for it to function.
Answer By: Willys Jeep Parts Tech on Oct 18 2017 12:58 PM
Questions: How can I easily unfasten the speedometer cable from the transfer case I cannot get any reasonable access to unfasten knurled fastener?
Question By: Chris Bowman on Sep 17 2017 12:26 AM
It just unscrews off. It is standard thread.
Answer By: Willys Jeep Parts Tech on Sep 18 2017 5:48 AM
Questions: which speedometer would you recommend for my 1955 cj5 three speed. I would like it to have gas gauge temp gauge and have lights.
Question By: jim on Aug 26 2017 10:51 PM
This should be the one you're looking for: 999845. Thanks
Answer By: Willys Jeep Parts Tech on Aug 28 2017 12:08 PM
Questions: Is the Nippon Seiki speedometer original to the 1949 CJ-3A or is it an aftermarket replacement? I need a speedometer cable for the Nippon Seiki speedometer,but not sure if it works with this model speedometer.
Question By: Jeff on May 4 2015 12:00 AM
This is the proper speedometer cable for the OEM speedometer used.
Answer By: Willys Tech on May 5 2015 12:00 AM
Questions: Where can I find where to route the speedometer cable on a 1950 Jeep
Question By: Charlie on Jan 13 2015 12:00 AM
Its attaches to the passenger side of the rear of the transfer case just in front of the emergency brake backing plate.
Answer By: Willys Tech on Jan 13 2015 12:00 AM
Questions: Where does cable fit on transmission ?
Question By: Nadine on Oct 10 2014 12:00 AM
Its goes to the rear cap of the transfercase.
Answer By: Willys Tech on Oct 10 2014 12:00 AM
Questions: I have a 43 gpw. will this fit without any adaptors? What about your cable that is 53 1/2 long also listed for this vehicle?
Question By: karen on Sep 8 2014 12:00 AM
This works for the MB/GPW. Also part number: 643799 is just like original.
Answer By: Willys Tech on Sep 9 2014 12:00 AM
Questions: Will this fit '69 commando original 3 speed manual v6?
Question By: Anonymous on Aug 25 2014 12:00 AM
It should as long as you have a D18 transfercase with a 60 long cable.
Answer By: Willys Tech on Aug 26 2014 12:00 AM
Questions: I have a 54 willys cj3B and the speedometer cable has a notch on the end that goes into the transfer case. I can't tell but it dose not look like this cable has one. if you know what I need I would appreciate the help.
Question By: Anonymous on Apr 29 2014 12:00 AM
That is because you have a military speedometer cable/transfercase. That style is part number: MSPEEDO - this part 643797 will work for you however. They are interchangable.
Answer By: Willys Tech on Apr 30 2014 12:00 AM
Questions: I have a T-150 transmission is there a o-ring or a seal that goes between the speedometer cable and the transmission.
Question By: Ron on Feb 12 2014 12:00 AM
No, there is no seal to the speedometer cable the rear transfercase bearing cap where it attaches.
Answer By: Willys Tech on Feb 17 2014 12:00 AM
Questions: My speedometer jiggles erratically around 15 mph at any speed (1947 CJ2A). Is the cable/connection at fault or the speedometer itself?
Question By: Robin Craviotto on Aug 23 2013 12:00 AM
The gear in the transfercase may be worn. I would also check your cable and the speedometer as well.
Answer By: Willys Tech on Aug 26 2013 12:00 AM
Questions: will this fit the M38A1?
Question By: Drew on Mar 30 2013 12:00 AM
They will work ok. The proper part number is: MSPEEDOCABLE for M38 & M38A1
Answer By: Willys Tech on Apr 1 2013 12:00 AM
Questions: I have a 1969 Jeep CJ5 with V6 engine and 3 speed transmission with single stick Dana transfer case. Is this the correct cable for it? I know it says it is in the description but just want to make sure.
Question By: Doug Ryland on Dec 31 2012 12:00 AM
Yes this one will be the correct one for you.
Answer By: Willys Tech on Jan 2 2013 12:00 AM
Questions: Will this speedometer cable work on new guages.
Question By: todd on Dec 29 2012 12:00 AM
Yes it is the proper cable for you.
Answer By: Willys Tech on Jan 2 2013 12:00 AM
Questions: I have a 1970 CJ5 that someone swapped a SBC and a T-14 3 speed and D20 transfer case from a later Jeep. It was originally a V6 Jeep with a T-14 and D18 transfer case I think. Will this speedometer cable fit my speedometer and d20 transfer case?
Question By: Roger on Dec 13 2012 12:00 AM
I think with the D20 they are different.
Answer By: Willys Tech on Dec 13 2012 12:00 AM
Questions: Does the new cable need to be lubricated or does it come ready to go?
Question By: Eric on Apr 22 2012 12:00 AM
They are ready to go but grease never hurts.
Answer By: Willys Tech on Apr 23 2012 12:00 AM
Questions: Is there a better pic of the speedometer end? Ive got an older Stewart Warner speedo and I want to be sure it fits that and my Dana 18
Question By: Anonymous on Jan 30 2012 12:00 AM
This will for sure fit on your Dana 18. It is to OEM spec. Please call us toll free. We are more than happy to take measurements for you.
Answer By: Willys Tech on Jan 31 2012 12:00 AM
Questions: I have the cable but the end that goes into the gear is too small. Am I missing a piece?
Question By: Anonymous on Jan 8 2012 12:00 AM
Sounds like your missing the piece on the transfercase. Please call us toll free. We can probably get you fixed up.
Answer By: Willys Tech on Jan 9 2012 12:00 AM
Questions: will this one fit in a 1952 m38 jeep thanks
Question By: bob on Nov 7 2011 12:00 AM
I would use part number: MSPEEDOCABLE
Answer By: Willys Tech on Nov 7 2011 12:00 AM
Questions: WILL THIS FIT IN THE SW SPEEDOMETER AND WORK PROPERLY?
Question By: Anonymous on Nov 4 2011 12:00 AM
Yes this is the right one for the Willys Station Wagon too.
Answer By: Willys Tech on Nov 7 2011 12:00 AM
You Might Also Be Interested In
Weekly Willys highlights and discounts sent to your inbox
