Questions & Answers
Questions: Have a 68' with the V6. Looking at the U joints the front appear smaller than the rear. Is this correct and if so, which axle do these fit?
Question By: Jeremy Knakmuhs on Nov 23 2019 3:13 PM
They are typically the same. Please measure your joints and confirm they match up to these. We should be able to help either way.
Answer By: Willys Jeep Parts Tech on Nov 25 2019 5:30 AM
Questions: I have a 1968 Commando with a 4F cylinder that came stock.. Will these universal joints fit? Application shows V6 engine
Question By: Jerry Mercer on Jun 27 2018 2:01 AM
Just double check your measurements are the same and it is the correct part.
Answer By: Willys Jeep Parts Tech on Jun 27 2018 5:56 AM
Questions: I have a 1960 CJ5 with the F-134 engine. The front driveshaft U-Joint has different sized bearing caps. One cap is 1.063" which attaches to the transfer case yoke and the other cap is .938"diameter, which attaches to the driveshaft. The u-joint's Overall length is 3.218". Is the u-joint available?
Question By: David Thomas on Nov 4 2017 3:14 AM
That would be unusual in a 1960. Please call us toll free and ask for Mike M. with your measurements. I can try to help out.
Answer By: Willys Jeep Parts Tech on Nov 6 2017 5:49 AM
Questions: I have a 1971 CJ5 with the 4 cylinder engine will these work for front drive shaft it looks good I know it needs 2 internal and two external caps and size looks right . Thanks
Question By: Doug on Jul 4 2013 12:00 AM
Yes as long as your measurements match up to the numbers above they will be correct. These are just like original.
Answer By: Willys Tech on Jul 8 2013 12:00 AM