Questions & Answers
Questions: Hello Mike, what is the overall length of the Countershaft Cluster Gear . I may have to machine (smooth out) the 33-teeth front side because of thrust washer pitting. I also noticed that the 14-teeth gear has no notches to hold the thrust washer. Thank you.
Question By: Harald Giess on May 18 2022 2:36 PM
Answer By: Willys Jeep Parts Tech on May 18 2022 11:08 AM
Questions: Does this come with the bearing spacer sleeve?
Question By: Dan on Sep 12 2016 11:56 PM
That is a separate item. This is for the cluster gear only.
Answer By: Willys Jeep Parts Tech on Sep 13 2016 6:01 AM
Questions: i have a 54 cj3a and have all of the other parts for my trans. Exept for the clutch hub, can I get this part without buying the entire kit?.
Question By: billy on Jul 6 2014 12:00 AM
Answer By: Willys Tech on Jan 1 1970 12:00 AM
Questions: If I can't go into first or reverse, but can go into second and third, is this the part I need or should I check the fork too?
Question By: Anonymous on May 22 2014 12:00 AM
You may want to check your reverse idler gear as well as your sychronizer.
Answer By: Willys Tech on May 27 2014 12:00 AM
Questions: Transmission in 51 CJ3A had been working fine, then without warning I can't shift from 1st to 2nd gear. I can still shift into 1st and reverse. Any ideas what the problem may be?
Question By: Brad on Apr 21 2012 12:00 AM
It is probably worn gears or shift fork. I would take off your top shifter and inspect the teeth.
Answer By: Willys Tech on Apr 23 2012 12:00 AM
Questions: will the 35 tooth work in a 33 tooth tranny and just raise the gear ratio alittle?
Question By: ben briggs on Apr 15 2012 12:00 AM
It should but I doubt youll get much difference going down the road.
Answer By: Willys Tech on Apr 16 2012 12:00 AM
Questions: is this cluster gear for a t90a or a t90c or is it available in both?
Question By: bill on Apr 3 2011 12:00 AM
This is proper for both.
Answer By: Willys Tech on Apr 4 2011 12:00 AM