Questions & Answers
Is this cluster gear USA or INDIA made I won’t touch anything made in china as their fits and tolerances are terrible thank you
Willys Jeep Parts Tech:
These are not made in China. Please give us a call and we can help answer your question.
These are not made in China. Please give us a call and we can help answer your question.
Hello Mike, what is the overall length of the Countershaft Cluster Gear . I may have to machine (smooth out) the 33-teeth front side because of thrust washer pitting. I also noticed that the 14-teeth gear has no notches to hold the thrust washer. Thank you.
Willys Jeep Parts Tech:
7"
7"
are the internal shaft diameters of the cluster gear constant throughout all applications of the t 90 transmission my box is from a c j 2 and i need a new cluster gear set many thanks for any info.
Willys Jeep Parts Tech:
This is the one for your CJ-2A. Some later T90's used 643702 but its rare.
This is the one for your CJ-2A. Some later T90's used 643702 but its rare.
Does this come with the bearing spacer sleeve?
Willys Jeep Parts Tech:
That is a separate item. This is for the cluster gear only.
That is a separate item. This is for the cluster gear only.
i have a 54 cj3a and have all of the other parts for my trans. Exept for the clutch hub, can I get this part without buying the entire kit?.
Willys Tech:
http://www.kaiserwillys.com/category/T-90-transmission-diagram
http://www.kaiserwillys.com/category/T-90-transmission-diagram
If I can't go into first or reverse, but can go into second and third, is this the part I need or should I check the fork too?
Willys Tech:
You may want to check your reverse idler gear as well as your sychronizer.
You may want to check your reverse idler gear as well as your sychronizer.
Transmission in 51 CJ3A had been working fine, then without warning I can't shift from 1st to 2nd gear. I can still shift into 1st and reverse. Any ideas what the problem may be?
Willys Tech:
It is probably worn gears or shift fork. I would take off your top shifter and inspect the teeth.
It is probably worn gears or shift fork. I would take off your top shifter and inspect the teeth.
will the 35 tooth work in a 33 tooth tranny and just raise the gear ratio alittle?
Willys Tech:
It should but I doubt youll get much difference going down the road.
It should but I doubt youll get much difference going down the road.
is this cluster gear for a t90a or a t90c or is it available in both?
Willys Tech:
This is proper for both.
This is proper for both.
