Questions & Answers
Questions: I broke the end off of the grease fitting and am not abe to find one that fits. They seem to be a pipe thread. Went to a local nut & bolt store they said it's a 3/8 pipe thread but can't get over half a thread. What comes with the kit thread right in to the bottom and no resistance like they are not tapped for pipe thread. tryed 3/8 and 10 mil. streight thread and the same thing. Any ideas ??
Question By: kenneth g fiene on Jul 15 2021 6:53 PM
We should have some. Please email firstname.lastname@example.org on.
Answer By: Willys Jeep Parts Tech on Jul 16 2021 5:54 AM
Questions: What is the recommended torque for your greasable spring shackle? (‘68 CJ5)
Question By: Tracy Dunham on Jun 9 2021 12:51 AM
You can use this one as a heavy duty shackle or 802061 & 802062 for the standard shackles. Thanks
Answer By: Willys Jeep Parts Tech on Jun 11 2021 8:57 AM
Questions: I have a 1953 CJ3B, will these work on my springs?
Question By: Nate Spence on Feb 18 2021 6:22 PM
928764 is a good heavy duty option for your CJ-3B
Answer By: Willys Jeep Parts Tech on Feb 18 2021 10:34 AM
Questions: I purchased these for my 70 CJ5. Do I take out the rubber bushings and use the brass one that come in the kit? Or did I order the wrong thing
Question By: Randy on Jul 28 2020 4:11 PM
You would just use the bushings with the shackle. Please email email@example.com if you have any questions. Thanks!
Answer By: Willys Jeep Parts Tech on Jul 28 2020 10:20 AM
Questions: My M38A1 had no suspension on it when I got it, so I have nothing to base my purchases upon. Do these require springs that have no bushings in them? Or springs with a specific bushing already installed?
Question By: Adam on Jul 5 2016 6:55 PM
928764 would be the proper shackle for your M38A1. It comes with bushings complete.
Answer By: Willys Jeep Parts Tech on Jul 5 2016 11:57 AM
Questions: i have a 42 mb and ordered the 2.5 lift springs from rancho. Do I still use the c shackles or what?
Question By: jerry on Nov 18 2014 12:00 AM
Rancho doesn't make a proper kit for the MB to my knowledge.
Answer By: Willys Tech on Nov 18 2014 12:00 AM
Questions: Are these shackles greasable
Question By: Nick on Aug 20 2012 12:00 AM
Yes these are greasable
Answer By: Willys Tech on Aug 21 2012 12:00 AM
Questions: Do the flat washers go on the inside (against the ends of the bushing) or on the outside of the side plates (under the bolt head and nut)? Thanks again. John
Question By: John on Aug 17 2011 12:00 AM
On the outside
Answer By: Willys Tech on Aug 17 2011 12:00 AM