Product Videos
Questions & Answers
Is it necessary for teh Main Shaft Gear to just slide in place? My main shaft gear requires a punch to drive it all the way down to its seat. Secondly, is it required for the main shaft gear to spin freely when it is in place. Both my shaft and gear came out of my transfer case - they are not replacement parts.
Willys Jeep Parts Tech:
Sounds like its being held up. Email mike@Kaiserwillys.com some more vehicle information and we can help. Its a straight cut shaft.
Sounds like its being held up. Email mike@Kaiserwillys.com some more vehicle information and we can help. Its a straight cut shaft.
Do I need to order the pilot bushing with this or does it come already installed?
Willys Tech:
Yes, please refer to the 3rd image. You can see it's pressed in already.
Yes, please refer to the 3rd image. You can see it's pressed in already.
How do I know when I have enough end play in the out put shaft on the dana 18 transfer case
Willys Tech:
For the correct bearing adjustment the shaft should have .004 to .008 end play. Adjustment is made by shim installation between the end cap and main case. Do not install rear bearing cap oil seal until the bearings are correctly adjusted.
For the correct bearing adjustment the shaft should have .004 to .008 end play. Adjustment is made by shim installation between the end cap and main case. Do not install rear bearing cap oil seal until the bearings are correctly adjusted.
YOU MIGHT ALSO BE INTERESTED IN
