Questions & Answers
Questions: Does this come assembled as one unit
Question By: Jack Wood on Jun 10 2019 10:17 PM
Yes, that is correct.
Answer By: Willys Jeep Parts Tech on Jun 11 2019 5:41 AM
Questions: 1972 CJ5 is my jeep. I need to replace the original. Outside tab has fallen off. Whar are the measurements of this item. The original piece is an 1.5 inches long with the holes 1 inch on center.
Question By: Jason McLeskey on Aug 11 2018 1:48 PM
2-1/8" center to center mounting.
Answer By: Willys Jeep Parts Tech on Aug 13 2018 6:17 AM
Questions: Does this horn brush require removal of brass so the cover will sit down on the outer tube? I have replaced the horn contact bushing and horn button repair kit. Even though the hex on the brass is fully inserted into the plastic insulator, there is about 1/8 gap before the cover will sit down on the outer tube.
Question By: jeepcreep on Jan 1 1970 12:00 AM
You take part number A302B and slide it down the shaft. Then A302 contact should hit the brass on the bushing. You sauder your wire then to the A302B. Make sure not to melt the rubber insulator.
Answer By: Willys Tech on Jan 1 1970 12:00 AM
Questions: What would be the proper gage wire to connect this to the horn relay on a 12-volt conversion?
Question By: jeepcreep on Jul 14 2014 12:00 AM
I think it takes a 16 gauge wire but will have to confirm.
Answer By: Willys Tech on Jul 15 2014 12:00 AM
Questions: Will this work with the Ross steering on a 66-71 CJ5?
Question By: Chuck on May 28 2012 12:00 AM
Im sure it could be used just fine if you wanted.
Answer By: Willys Tech on May 29 2012 12:00 AM
Questions: Do you stock this item? Do you ship international?
Question By: Murray Connell on Dec 13 2010 12:00 AM
Yes, we stock this item and ship daily USPS and UPS international.
Answer By: Willys Tech on Dec 13 2010 12:00 AM