Temperature Switch Sending Unit 12 volt (engine unit)
Fits 46-71 Jeep & Willys with Stewart Warner gauges

Questions: on willys pickup can not get water temp gauge to work, at some point the gauge cluster was replaced with new, and truck was converted to 12 volt. i replaced temp sender with 12 volt model, grounded engine to frame, checked sending wire, when you turn key on temp gauge goes to left off cold mark. fuel gauge does work, on red jumper wire reads 12 volt and sending wire term reads 5volt, should i still be using the small silver relay box for power to I term on fuel gauge. any help would be great

Questions: Is this the correct temperature sensor for the Super Hurricane 6-226 engine (1961 4WD pickup, 12 volt system)? Thank you.

Questions: Will this switch work with 999845?

Questions: I purchased this for my CJ5 f134, it seams the new sensor does not thread into the cylinder head and the old threaded spacer ring is ceased to the old sensor. Do I need a different part or will the new sensor fit in the old ring once removed?

Questions: I have a 24 Volt, 1954 M38a1. Do you have a temp sending unit for 24v?

Questions: Will the sending unit work with Item # 914845A and read correctly according to the ohms?