Questions & Answers
is there a new steering gear box that would bolt up fairly easily, there are lots of them out there but , I try to buy parts from K/W , better service , higher quality, I have rebuilt ross boxes, replaced upper/lower kingpin bearings with proper bearing loads, replaced front wheel bearings, tie rod ends, shocks, springs. am trying the tight steer add-on, but a new steering gear would be the icing on the cake. thank you .
Willys Jeep Parts Tech:
Email mike@kaiserwillys.com and we can help you out on. Thanks!
Email mike@kaiserwillys.com and we can help you out on. Thanks!
could this potentially replace a gearbox in a cj2a to eliminate the slop?
Willys Jeep Parts Tech:
It would be complicated and you would have to completely redo your steering. We have complete gear box repair kits available that will eliminate your slop. Email mike@kaiserwillys.com happy to help.
It would be complicated and you would have to completely redo your steering. We have complete gear box repair kits available that will eliminate your slop. Email mike@kaiserwillys.com happy to help.
will this box fit a 1968 jeep cjs f134 4cyl
Willys Tech:
It is different but im sure anything is possible with modification.
It is different but im sure anything is possible with modification.
can I swap out my Ross gear box with this unit? I have an M38A1. How would you connect t the steering shaft?
Willys Tech:
This really is only for the Jeeps listed above. However im sure anything is possible with modification.
This really is only for the Jeeps listed above. However im sure anything is possible with modification.
YOU MIGHT ALSO BE INTERESTED IN
